I can declutter a bit because I won't need separate MOCA adapters on each floor anymore. The coax (up to 2.5Gbps) would still be the network backbone. Ethernet ports on the back are still open for devices on the same floor. If my understanding is correct, for each of my three floors, I can take out the MOCA adapter and Wifi 5 WAP, and replace it with the all-in-one Wifi 6 WAP and plug the coax right into it. My hope is that I don't need to use the MOCA adapters anymore and just setup new Wifi 6 WAPs, using the coax backbone, and get >90% of the fiber service anywhere in my home. The new Wifi 6 wireless access points (WAP) have a coax plug already. Of the 100Gbps download and 32 Gbps upload service (pre-fiber), I can get >90% from any place in my home. On each floor, I have a MOCA adapter connected to a Telus Boost Wifi 5 pad. We do not use it for any coax TV signals. I use MOCA exclusively as a network backbone. Currently, I have the T3200M router as the main modem/router. I'm excited to get fiber installed next week, but have a few network design questions. My initial tests came up with the following results, with the LAN Speed Test and Windows drag-and-drop methods producing similar results.If I setup a Wifi 6 WAP on each floor, can I just plug-in the coax backbone, or do I still need to use the MOCA adapters? Both tests were run in two directions, measuring write and read throughput.Īs a point of reference, I previously measured my old Actiontec ECB2500C MoCA 1.1 adapters at ~ 100 Mbps throughput for both write and read. The second method used Windows drag-and-drop filecopy of a 4 GB media file. Ir then calculates the read and write throughput. According to the official publisher of LAN Speed Test (Lite), this tool builds a file in memory, then transfers it both ways to a target network shared drive (without effects of windows file caching) while keeping track of the time. The first set of benchmarks used LAN Speed Test Lite with 1500 MB file size. All you have to do is connect one adapter to a coax jack and into your router and connect.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |